Use a tray and put it under the freezer in the
direction of the dripping tube. Take out the
obstructing plug. The water which results will
be collected in the tray.
After the melting of the ice and the run-off of
the water please wipe with a cloth or with a
sponge, then dry well. Put the obstruction plug
back in its place. (Item. 6)
For a fast thaw please leave the lid open.
Do not use sharp metal objects to remove
the ice.
Do not use hairdryers or other electric
heating appliances for defrosting.
Inside cleaning
Before starting the cleaning, unplug the
appliance from the mains.
It is advisable to clean the appliance when
you defrost it.
Wash the inside with lukewarm water where
you add some neutral detergent. Do not use
soap, detergent, gasoline or acetone which
can leave a strong odour.
Wipe with a wet sponge and dry with a soft
cloth.
During this operation, avoid the excess of
water, in order to prevent its entrance into the
thermal insulation of the appliance, which
would cause unpleasant odours.
Do not forget to clean the door gasket
especially the bellow ribs, by means of a
clean cloth.
Outside cleaning
Clean the outside of the freezer by means
of a sponge soaked in soapy warm water,
wipe with a soft cloth and dry.
The cleaning of the outside part of the
refrigerating circuit (compressor, condenser,
connection tubes) will be done with a soft
brush or with the vacuum-cleaner. During this
operation, please take care not to distort the
tubes or detach the cables.
Do not use scouring or abrasive materials!
After having finished the cleaning, replace
the accessories at their places and plug in the
appliance.
Defects finding guide
The appliance does not work.
There is a power failure.
The plug of the supply cord is not inserted
well into the socket.
The fuse is blown.
The thermostat is in „OFF” position.
The temperatures are not low
enough(red LED on).
The food prevents the door closing.
The appliance was not placed correctly.
The appliance is placed too close to a heat
source.
The thermostat knob is not in the correct
position.
Excessive ice build-up
The door was not closed properly.
The following are not defects
Possible noddings and cracks coming from
the product: circulation of the refrigerant in
the system.
To Next Page
