Gram FS User Manual

44
GB
NB! During freezing down, the temperature
shown on the display is always 1°C lower
than the temperature at which the cabinet
was set before the freeze-down function
was selected.
Normal condition. The panel shows the
actual freezer temperature, here -18°C.
Temperature setting: Press TEMP and hold
it down. In a moment or two the display will
show the temperature setting, in this case
the factory setting of -18°C.
When all lamps in the scale light up, the
temperature in the freezer is -14°C or higher
than can be shown on the scale.
When the lamp under -21 lights up - and
only this lamp - the freezer temperature is
lower than can be shown on the scale.
When the two lamps at either end of the
scale flash alternately and the four middle
lamps light up there is a fault in the tempe-
rature sensor. Call a service technician. (In
the event of sensor fault an emergency pro-
gram will take over control until the service
technician arrives).
-21 I -14 TEMP. FREEZE
-21 I -14 TEMP. FREEZE
-21 I -14 TEMP. FREEZE
-21 I -14 TEMP. FREEZE
-21 I -14 TEMP. FREEZE
-21 I -14 TEMP. FREEZE
Alarm: The lamps light up one after the
other along the scale, starting at the coldest
end. An acoustic alarm is given at the same
time.
When the lamp at the side of the FREEZE
key lights up, freezing down is in progress.
Freezing time setting: Press FREEZE and
hold it down. In a moment or two, one lamp
or two lamps on the display will light up.
The number of lamps that light up indicates
the selected number of freezing-down days.
NB! During freezing down, the temperature
shown on the display will be
either
the actual temperature
(down to -21°C)
or
1°C lower than the temperature at
which the cabinet was set before the
freeze-down function was selected.
-21 I -14 TEMP. FREEZE
-21 I -14 TEMP. FREEZE
-21 I -14 TEMP. FREEZE
List of signals

Gram FS Specifications

General

Brand	Gram
Model	FS
Category	Freezer
Language	English