76-504-0648 19
Starting up
Hidden key Arrow key up
Time setting Arrow key down
Chilling temperature Main switch
Storage temperature
Press the main switch to start.
The figures now displayed give the actual temperature in the cabinet and at the
same time confirm that power is on.
The cabinet is now ready for programming and/or starting up. See section on
programming and program sequence.
NOTE:
1. Servicing
Make sure the appliance is switched off at the socket before service is performed
on electrical parts. It is not sufficient to switch off the cabinet by the ON/OFF key
as there will still be voltage to some electrical parts of the cabinet.
2. Starting up in tropical conditions
When starting the appliance in an ambient temperature of around 40°C or higher,
the display will show sensor fault F1 - F2 (because the sensor cannot register
temperatures higher than 40°C).
About 10 - 15 minutes after compressor start, the actual temperature will be
shown in the display (when the temperature has fallen to under 40°C).
Program variants
The cabinet offers the following program possibilities:
1: Storage program.
2: Time-controlled chilling.
3: Temperature-controlled chilling.
4: Combination of time and temperature-controlled chilling.
To Next Page