Grammer MSG 90.6PG - Page 130

Repair Manual MSG 90.6PG Commercial Vehicles, Omnibuses – November 2017
Material no. 1153450_c
3.8 Bowden pull wire for seat height adjustment –
inspection and adjustment
Page 5 of 6
INSPECTION ADJUSTMENT TABLE OF CONTENTS
5 Hold the nut (7) in position and secure
the adjustment with the counternut (6).
Note:
Make sure not to distort the Bowden
pull wire for seat height adjustment
(1).
6 If the Bowden pull wire for seat
height adjustment (1) has been
removed:
Hang in the Bowden pull wire for seat
height adjustment (1) at both ends
(see Chapter 3.9).
7 Install the Bowden pull wire for seat
height adjustment (1) (see
Chapter 3.9).
8 Operate the handle for seat height
adjustment (2) several times in both
directions, check it for correct
functioning and readjust it, if
necessary.
8
6
9
8
9
1
7
5
A
1
1
2
4
3
5
7
6
2178