Grammer MSG 90.6PG - Page 400

Repair Manual MSG 90.6PG Commercial Vehicles, Omnibuses – November 2017
Material no. 1153450_c
3.48 Bowden pull wire and bearing for optional backrest adjustment –
removal and installation (delivery option)
Page 8 of 8
REMOVAL / INSTALLATION TABLE OF CONTENTS
19 Pull off the lever for backrest
adjustment (23) at the axle of the
bearing (10) and remove it together
with the angle plate (14).
20 Pull off the handle for optional
backrest adjustment (15) at the lever
(23).
21 Pull the lever (23) out of the angle
plate (14).
22 Bore off the rivet head, drive the
blind rivet (17) out of the bearing (10)
and backrest (5) and remove the
bearing (10).
23 If the leaf spring (11) is defective:
Bore off the rivet head, drive the
blind rivet (12) out of the leaf spring
(11) and bearing (10) and remove
the leaf spring (11).
24 Re-install the components in the
reverse order of their removal.
2
4
1
3
15
14
16
13
18
1
10
21
11
17
19
20
5
22
13
23
10
12
15
1
1
8
9
7
1
1
2
8
3
3
4
2
6
2483