Grammer MSG65 - Armrest Adjustment and Folding; Armrest Inclination Adjustment; Backrest Extension Adjustment

Seat functions and operation
GB
23
767
A rm rests * * *
The armrests can be folded back if required
and the height individually adjusted.
To adjust the armrests for height, separate
the round cap (see arrow) from the cover,
loosen the hexagon nut (size 13 mm) behind
it and adjust the armrests to the desired
position (5-steps) and tighten the nut
again (
Ð.Ñ5ÒÓ
). Replace the cap onto the nut.
ÔQÕÖ
Ò× ÒØÙ
If the belt roller is fitted, do not install the
armrest in the lowest position as otherwise
the belt roller might not function correctly.
Carry out a
Ú;ÛÜ5Ý@Þ;ß àÜ%á0â>Þ ã'ä.Þ
of the belt roller.
+
-
768
A rm rest adj ustm ent *
The inclination of the armrests can be
modified by turning the adjustment knob.
When turning the knob to the outside (+) the
front part of the armrest will be lifted, when
turning the knob to inside (-) it will be lowered.
769
B ack rest ex tension * * *
The backrest extension can be individually
adjusted by pulling it upwards or pushing it
downwards over the various locking
increments up the end stop.
To remove the backrest extension, pull it
upwards over the end stop.
* if fitted ** optional extra