EasyManua.ls Logo

Grammer MSG65 - Page 6

Grammer MSG65
11 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Safety instructions
GB
19
\Z]^._3`5a%b0^5c0d'ef)gEf;a%d3e%d0h;i d'ee.f b0^5j0b0h)j<g5kf;a%d3e%d.b'f
(for example fitting parts which are not
original
lm
]nno
m
AG parts) may impair the safety standard to which it has been tested.
pq
^5`@f;i g^.e,rEb'_s%d,i rJt%b0i h d%j
, threatening your
e%b'k d'f _
. For this reason,
b0^._3`5a%b0^5c0d,i ^
j0d'ei c^Eg5kf;a%d3e%d.b'f
must be approved by
lm
]nno
m
AG.
\
During the removal and installation of the driver’s seat, the corresponding instructions by
the specific vehicle manufacturer must be strictly observed!
\
Do not hold onto the covers for lifting the driver's seats. If you do so anyway, there is an
i ^5`5h d.b'e%d%jBh;i eug5ki ^>v
q
h _3j
q
d3f)gBw gg5e%d0^i ^5c<ghsh d.b0u.i ^5c<`.g5x%d0h e
.
\
Before you remove the driver’s seat, disconnect all plug-in connections between the seat
and the vehicle supply network. When you replace the plug-in connectors, make sure they
are tight (dust, water).
\
Seatbelts are fitted or can be retrofitted to the driver’s seat. Seatbelts
rEb'_3g^w _s%d3k;i f f d%j
g^f;a%db0tth)g5x%b0w'g5kf;a%d3x%d0ai `5w dErEb0^
q
k b%`@f
q
h d0h
, as they increase the load in the seat
mounting area.
Seatbelts must be fitted in accordance with specific national regulations and guidelines,
and must be approved by
lm
]nno
m
AG.
\
Seatbelts must be fastened
s%d'k)gh djh;i xi ^5c
.
y
a%d3e%d.b'f;s%d0w f e,r
q
e.fs%d,h d0tw b%`'d%j
after an accident.
Where seatbelts are fitted to the driver's seat, the
e%d.b'f
and
e%d.b'fr,g
q
^.f;i ^5c
must be
checked
b%jji f;i g^%b0w w _
by specialist personnel after an accident has occurred.
\
Fasteners must be
`5a%d%`5u>d%jBh d%c
q
w b0h;w _zk)ghf;i ca.fe%d.b'f
. If the seat wobbles, there may be
loose bolts or other faults.
\
If you notice that the seat does not function correctly (for example a defective suspension
of the driver's seat; improper curvature of the lumbar support or damaged bellows),
`.g^.f b%`@fIb3et%d%`5i b0w i e.f{3gh;u|ea5gt
i r<rEd%ji b'f d0w _
to arrange for repairs to be carried out.
If you fail to do so, your health may be affected and the
h;i eug5kIb%`.`5i j0d0^.fi ^5`5h d.b'e%d%j
.
\
Before the vehicle is used, switches that might be in the seat (for shutting down
mechanical equipment when the driver leaves his/her seat) must be checked for
th)gt%d0h
k
q
^5`@f;i g^
.
If malfunctions are detected, the vehicle must not be driven.
} ~Tm
o]o
m}
Q
p
]
T}
o
~
y
\H5g0b%j5e,r
q
e.f^5g5fs%d,tw b%`'d%j<g^e%d.b'f e{i f;ab,s
q
i w f))i ^e.{i f)`5a
, except for the driver’s
weight during normal use, as the vehicle may otherwise start to move by itself.
} ~Tm
o]o
m}
Q
p
]
T}
o
~
y
If you take off the weight from the seat while driving, this will cause the vehicle to stop.
\
Do not indent the bellows while there is load on the driver’s seat.
m}
Q
p
Tm

} ~l
\
Make sure that the
i ^.f d0h;i ghg5kf;a%djh;i x%d0h) ee%d.b'f
remains free of
k)gh d0i c^<t%b0h f;i `5w d'e
or
w i
q
i j5e
.

Other manuals for Grammer MSG65