Edit Handsets Name from DP75x
Changing the Base PIN Code
Users can change their code PIN by following the steps below:
Using DP Handsets:
1. Press Menu to bring up the operation menu.
2.
Use arrow keys to reach Settings .
3. Navigate to select System Settings, and then press “Select”.
4. Enter the current code PIN (By Default is 0000), a new window will be displayed inviting you to enter the new password,
when done press “Save” (left softkey) and a prompt message will be displayed to confirm that the new code PIN has been
saved successfully.
Changing Admin Base PIN Code from DP Handset
Using DP75x Base Station UI:
1. Access DP75x Web interface.
2. Go to DECT 🡪 General Settings.
3. Set a new PIN code in the Admin PIN Code field.
Note: Only digits are accepted. The minimum allowed length is 4 digits.
Note
Handset firmware can NOT downgrade to 1.0.19.15 or below.
To Next Page
Loading...
