GDS371x Back Cover
Power the unit using PoE
Cut into the plastic sheath of your Ethernet cable, then Unwind and pair as shown below.
Use the TIA/EIA 568-B standard, which define pin-outs for using Unshielded Twisted Pair cable and RJ-45 connectors for Ethernet connectivity.
Connection Example
Connect each wire of the cable to its associate on the Back Cover of the GDS371x to power the unit using PoE.
Power the unit using PSU
To power the unit using PSU, use a multimeter to detect the polarity of your Power Supply, then connect GND to negative pole and 12V to
positive pole of the PSU.
Note
If the user doesn’t have PoE switch, there is no need to connect the Blue and Brown wires to the GDS371x since these wires are used to power the unit via
Ethernet.
To Next Page
Loading...
