GDS371x Wiring Connection
GDS371x Back Cover Connections
GDS371x Back Cover Connections
Connection Example
To connect the GDS either by using PoE or PSU follow steps below:
Open the Back-Cover Board of the GDS371x which should look like following figure.
WG_D1_OUT
Wiegand Output Signal
Orange
GDS3710 function as
Output of Card Reader,
Connect Pin 1, 2, 3
WG_D0_OUT Brown
LED Wiegand Output LED Signal Blue
For External Card Reader;
Or GDS3710 as Receiver
Only
WG_D1_IN
Wiegand Input Signal
White
For External Card Reader
Connect Pin 1,4,5,6,7,8
WG_D0_IN Green
BEEP Wiegand Output BEEP Signal Yellow For External Reader Only
5V Wiegand Power Output Red
For External Card Reader
Only.
12VDC powered External
Card Reader must use own
power source, can NOT
use this Pin.
To Next Page
Loading...
