The GSC3570 side also need to be configured according, like below:
GSC3570 secure open door via GDS3710-GSC3570 Door System System configuration
Then we will be configuring the Digital Input on the GSC3570 as the figure below:
GSC3570 secure open door via GDS3710-GSC3570 Digital Input
configuration
One-Way Interlocking Mode
This feature will allow GDS3710 to control two doors in one direction, with additional 3 party window/door sensor installed accordingly (not
provided by Grandstream). When configured and wired correctly, the two doors will operate under a controlling logic as below:
1) Only legal PIN or RFID card can open door when BOTH doors are detected closed. ( Only for GDS3710 Model )
2) When 1 door opened by valid user, the 2 door is and will remain closed; the 2 door will automatically open once detected the 1 door closed
and programmed timer reached.
3) When 2 door opening, the 1 door will NOT open even a valid PIN/RFID used. ( Only for GDS3710 Model )
4) If entering 1 door and after 1 door closed and 2 door opened, the person failed to enter 2 door promptly (after 2 door opening time out)
will be locked in between two doors until next transaction happens or ask help (e.g.: call posted number or press button if there is one) from security
staff to open door remotely (via SIP call into GDS3710 or GDSManager, for example).
Notes
If the solution/integration is using static IP address without SIP Proxy, all the devices involved (GDS/GSC/IP Phone) should set “NAT Traversal” to
“No” and should NOT “Use Random Port”, otherwise will have problem of ghost call (SIP signaling working but NO media).
The IP phone or GSC3570 can use any empty SIP account, meaning it can be mixed if Account 1 registered to UCM/Proxy and Account2 (blank) to
use IP (but the account has to be configured as “Active”).
Note
This configuration is exclusive to the GDS3710 Model.
rd
st nd nd st
nd st
st st nd nd nd
To Next Page
Loading...
