Grandstream Networks GDS371 Series - Page 39

There are four choices in the pull-down selection:
● Local Relay:Local Relay is the GDS371x controlling the relay. The strike is wired into the COM2 or COM1
port of the GDS371x depending 1 door or 2 door need to be controlled.
● Webrelay:When Webrelay is selected, customers need to continue congure the webrelay IP address or
domain name, together with credentials like Username and Password. When legal open door event
happened, the congured web relay will get the communication from GDS371x, and will operate the strike
to open door for the authenticated open door request.
● GSC3570 Relay:When the Door relay is set to GSC3570, it gives the option to connect it to the GSC3570
device by entering the Phone number and door password.
● Send Wiegand Code on Remote Open Door Action:When this mode is selected, The device will send
PIN1/PIN2 code via the Wiegand interface when the remote HTTP API open door1/door2 has been
executed.
Note:In web relay mode, the strike is wired to the web relay controller device.
Webrelay URL ON
When Door relay Option set to Webrelay, then enter the correct URL used by the third party controller so that
the GDS3710 send the command to activate the relay.
This adds an extra layer of security so when legal open door event happened, the congured web relay will get
the communication from GDS3710, and will operate the strike to open door for the authenticated open door
request or use that command to operate other industry application.
Notes:
● Now there are two Webrelay URL elds available, with On or Off URL command allowed or other usage URL
command allowed. Also allow Username and Password congured if the 3rdparty Webrelay requiring this
security feature.
● If some 3rdparty Webrelay only support one URL command, then just leave another Off URL blank, or put
whatever there as long as it is NOT a URL command.
Webrelay URL OFF
When Door relay Option set to Webrelay, then enter the correct URL used by the third party controller so that
the GDS3710 send the command to disable the relay.
Webrelay Username Enter the web relay username.
Webrelay Password Enter the web relay password.
ALMOUT1 Feature
This option allows to choose to use Alarm_Out (COM1) interface for either as alarm out with 3rdparty device,
or to control a second door “Door 2” (the two functions are mutual exclusive).
When the option “Open Door” is selected, will enable GDS3710 to control the operation of two doors via RFID,
and local and remote PINs.
ALMOUT1 Status Select Normal Open or Normal Close depending on the lock used.
Delay before Unlock (s) Device will open door after specied delay (in seconds) when user issuing the authorization.
Unlock Holding Time (s)
Congures the lock holding time, in seconds (default value is 5 seconds).
Device will hold the door unlocked for this specied duration.
Range: 1-1800 seconds.
One-way Interlocking Doors Mode
This option allowsto control two doors for access control in one-way mode. Once the card or PIN is fully
validated by the GDS3710, it will check the status of both doors (using 3rd party window/door sensors - not
provided by Grandstream - to verify if they are opened or closed), if
both doors are closed the Door 1 will open allowing the person to pass through hallway, once the Door 1 is
closed it will start counting and when the timeout is reached, the Door 2 will open granting access to the
person in the facility.
Note: This feature is available only at for GDS3710.
Control Options
Congures weather to allow the two doors to be controlled by local RFID cards or PINs for access.
Note: This feature is available only at for GDS3710.