Grandstream Networks GDS371 Series - Page 40

Wiegand Control
Congures weather to allow the two doors to be controlled by wiegand or keypad Input.
Note: This feature is available only at for GDS3710.
Door 1 Delay before Unlock(s) The device will open door 1 after the specied delay (in seconds) when user has issues the authorization.
Door 2 Delay before Unlock(s) The device will open door 2 after the specied delay (in seconds) when user has issues the authorization.
Door 1 Unlock Holding Time(s) The device will hold the door 1 unlocked for a while (1-1800 seconds)
Door 2 Unlock Holding Time(s) The device will hold the door 2 unlocked for a while (1-1800 seconds)
Minimum Interval of Swiping Card
(ms)
Denes the interval in ms to swipe consecutive RFID cards. The range should be between 0ms and 2000ms.
Note: option only available for GDS3710
Number of Snapshots when Door
Opened
Dene number of snapshot to be sent by the GDS (via FTP or Email)
Maximum up to 4 screenshots.
Snapshot when Door Opened
User can choose to email the snapshot when door is opened without sending the snapshots via FTP to the
FTP server.
Snapshot when Doorbell Pressed
User can choose to email the snapshot when doorbell pressed without sending the snapshots via FTP to the
FTP server.
Snapshot Delay when Door
Opened(s)
Congures the delay in seconds to the snapshots taken when Door Opened.
The valid range is 0-10 seconds.
Default value is 0, meaning there will be no delay for taking the snapshot when door opened.
Snapshot Delay when Doorbell
Pressed(s)
Congures the delay in seconds to the snapshots taken when Doorbell pressed.
The valid range is 0-10 seconds.
Default value is 0, meaning there will be no delay for taking the snapshot when door pressed.
Call Mode Chooses whether to make call to the SIP number or Virtual Number when dialing from the GDS3710 keypad.
Doorbell Call Out Account
This option sets the account to be used to make call upon thedoorbell trigger. If set to Auto, the GDS will use
the rst available account.
Doorbell Mode
Congures the action to be taken when the doorbell is pressed, three options are available:
● Call Doorbell Number:when Doorbell is pressed, a call will be made to the “Number Called When Door Bell
Pressed”
● Control Doorbell Output (Digital Output 1):when Door Bell is pressed electronic lock for Output 1 is opened
with a time duration of (1s to 4s), Option availableOnly on GDS3710 Model
● Both of Above:When selected, both Call Doorbell Number and Control Doorbell Output options are enabled
, Option AvailableOnly on GDS3710 Model
Door Bell Call Mode
Select the ring strategy for the Numbers Called when pressing the Door Bell button to be
eitherSerialorParallel:
● Serial Hunting:the congured extensions and/or IP addresses will ring one after one by order.
● Parallel Hunting:The congured extensions and/or IP addresses will ring simultaneously (up to 4
simultaneous SIP calls).
Press Doorbell Schedule [1-4] Select the schedule when pressing the doorbell will call the congured destination.
Notes:
● Maximum 4 different “Schedule” can be congured.
● “Doorbell” Call Number or IP address must be congured in related “Schedule”
● The priority order of schedule is “Schedule 1, 2, 3, 4”. The device will rst check and verify currenttime ts
in “Schedule 1”, if yes it will dial out using the congured number in Number 1; if not it willcheck “Schedule