To Next Page

To Previous Page

Following commands have been run in a web browser on computer in same phone’s network. In the examples below, a

GRP26XX phone is used with IP address 192.168.5.135 and admin/user level password set to (passcode=admin).

Functions used on GRP26XX

Line Status Function

General Format

The general format of CTI command to retrieve the line status is:

http://Phone-IP-Address/cgi-bin/api-get_line_status?passcode=PASSWORD

Example

In this example, the phone shows that only one account is available on line 1; other lines are not registered.

Phone Status Function

General Format

The general format of CTI command to retrieve phone status is:

http://Phone-IP-Address/cgi-bin/api-get_phone_status?passcode=PASSWORD

Example

Request http://192.168.5.135/cgi-bin/api-get_phone_status?passcode=admin

Response

Phone available {“response”:”success”, “body”: “available”, “misc”: “0”}

Phone busy {“response”:”success”, “body”: “busy”, “misc”: “0”}

Request http://192.168.5.135/cgi-bin/api-get_line_status?passcode=admin

Response

{ "response": "success", "body": [ { "line": 1, "conf": 1, "state": "idle", "acct": 0, "active": 0, "remotename": "",

"remotenumber": "" }, { "line": 2, "conf": 1, "state": "idle", "acct": 0, "active": 0, "remotename": "", "remotenumber": ""

}, { "line": 3, "conf": 1, "state": "idle", "acct": 0, "active": 0, "remotename": "", "remotenumber": "" }, { "line": 4, "conf":

1, "state": "idle", "acct": 0, "active": 0, "remotename": "", "remotenumber": "" }, { "line": 5, "conf": 1, "state": "idle",

"acct": 0, "active": 0, "remotename": "", "remotenumber": "" }, { "line": 6, "conf": 1, "state": "idle", "acct": 0, "active": 0,

"remotename": "", "remotenumber": "" }, { "line": 7, "conf": 1, "state": "idle", "acct": 0, "active": 0, "remotename": "",

"remotenumber": "" }, { "line": 8, "conf": 1, "state": "idle", "acct": 0, "active": 0, "remotename": "", "remotenumber": "" }

] }

Grandstream Networks GRP260X Series Guide

Other manuals for Grandstream Networks GRP260X Series