INSTALLATION AND USE
STASH MULTI-TOOL
Multi-tool Spoke key tool
WWW.GRANITE-DESIGN.COM
5. Insert the tool housing into the steerer tube. Insert the M6 bolt with spacer through the bottom hole of the tool housing.
6. Insert the lower assembly through the fork crown. Tighten the M6 bolt to compress the headset assembly with the proper torque.
There should be no gap within the stem and headset stack and the headset should turn smoothly.
7. Align the stem to the front wheel and then tighten the stem bolts. Make sure the stem bolts are tightened before riding.
Riding with a loose stem can result in serious accidents.
8. Insert the tool set with top cap into the tool housing. Press firmly until the top cap flange touches the tool housing. Enjoy the ride!
USAGE AND MAINTENANCE
You should clean the tool regularly between uses. We suggest to apply a thin layer of oil onto the tool bits to prevent rust
in humid condition.
STASH MULTI-TOOL 2020.08.30 / REV. 1
To Previous Page
Loading...