14
4. Disconnect the power cord before starting maintenance or operation.
5. Protect against humidity.
6. Use appropriate attachment to drain water.
CAUTION! This device is designed to operate indoors.
The design is assumed to be safe, protection measures and additional safety systems are used,
nevertheless there is always a small risk of injuries at work.
CONSTRUCTION AND USE
Workshop vacuum cleaner is designed to suck non-ammable dusts, shavings etc. in dry operation mode,
or non-ammable liquids and water-air mixtures in wet operation mode.
The vacuum cleaner can work with power tools and suck o shavings and dusts appearing during power
tool operation. The device is designed for greater loads in industry applications, e.g. craft and repair
workshops and all works from the scope of individual, amateur activities (tinkering).
Designed for use with gypsum dust. When sucking o gypsum dust use pleated lter and dust bag.
Use the tool according to its purpose only.
DESCRIPTION OF DRAWING PAGES
Below enumeration refers to the device elements depicted on the drawing pages of this manual.
1. Transport handle
2. Power supply socket
3. Fixing clamps
4. Connection socket
5. Wheels
6. Container
7. Upper body
8. Switch
9. Drain plug
10. Support for wheels
11. Base
12. Power cord hook
* Dierences may appear between the product and drawing.
MEANING OF SYMBOLS
CAUTION
WARNING
ASSEMBLY/SETTINGS
INFORMATION
EQUIPMENT AND ACCESSORIES
1. Suction hose – 1 pce
2. Floor attachment – 2 pcs
3. Crevice attachment – 1 pce
4. Castor – 4 pcs
5. Telescopic pipe – 1 pce
6. Paper dust bag – 1 pce
7. Foam membrane – 1 pce
8. Pleated lter – 1 pce
9. Power cord hook – 2 pcs
10. Support for wheels – 4 pcs
11. Adaptor – 1 pce
To Next Page
Loading...
