EasyManua.ls Logo

Graphite 59G607 - Page 13

Graphite 59G607
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
13
TRANSLATION OF THE ORIGINAL INSTRUCTIONS
WORKSHOP VACUUM CLEANER
59G607
CAUTION: BEFORE USING THE DEVICE READ THIS MANUAL CAREFULLY AND KEEP IT FOR FUTURE
REFERENCE.
DETAILED SAFETY REGULATIONS
ADDITIONAL SAFETY RULES
Ɣ Before connecting the vacuum cleaner to a power network ensure the supply voltage matches the
voltage on the rating plate of the tool.
Ɣ Connect the vacuum cleaner only to electrical system equipped with residual current circuit breaker
that will cut the power o when earth leakage current exceeds 30 m
A
in less than 30 ms.
Ɣ Switch o the vacuum cleaner when the tank is lled with water.
Ɣ Keep the power cord of the device away from moving parts of other tools at all times.
Ɣ To connect the vacuum cleaner and vacuum cleaner with receiver use appropriate power cord designed
for outdoors operation and appropriate capacity.
Ɣ Protect power cord against spilled water, oil and other chemical substances.
Ɣ Do not use the vacuum cleaner in environment with explosive vapours, gases and in proximity of
explosive materials.
Ɣ Do not use the vacuum cleaner to gather glowing dust, or corrosive, explosive or ammable materials
or liquids, e.g. oils, solvents, petrol.
Ɣ Use lter appropriate for the planned task.
Ɣ Do not operate with full tank or dust bag. Empty the tank and replace dust bag regularly.
Ɣ Do not use the vacuum cleaner to clean fur on animals, clothes on persons, and drain water from
aquaria (risk for human and animal health).
Ɣ Protect the vacuum cleaner from rain.
Ɣ Do not expose the device to direct sunlight or other source of heat.
Ɣ Do not bring the suction attachment of the vacuum cleaner close to objects, which may be caught by
sucked air (risk of damage of objects and the vacuum cleaner).
Ɣ Do not open dirt container during operation of the vacuum cleaner.
Ɣ If the power cord is damaged during operation, disconnect the power supply immediately. DO NOT
TOUCH POWER CORD BEFORE DISCONNECTING THE POWER SUPPLY.
Ɣ Remove plug from mains socket:
Ɣ whenever you go away from the tool;
Ɣ before checking, cleaning or repairing the tool.
Ɣ Only authorized persons should repair the vacuum cleaner.
Ɣ Use only spare parts recommended by the manufacturer.
Maintenance and storing
Ɣ Keep all parts of the vacuum cleaner in good technical condition.
Ɣ To keep the operation safe, replace worn out and damaged parts.
Ɣ Keep the tool beyond reach of children.
Explanation of used symbols
1. Warning, use precaution measures.
2. Read instruction manual, observe warnings and safety conditions therein!
3. Use personal protection measures (protective goggles, earmu protectors, dust mask).

Related product manuals