16
Ɣ Pos 0 (middle position of the switch) – switched o.
Ɣ Pos II (bottom position of the switch) – vacuum cleaner can only be used with external device (power
tool) connected to power socket of the vacuum cleaner.
When using the vacuum cleaner to gather materials which are not harmful to health, they can be collected
in the tank (6) directly, use of pleated lter or dust bag is not necessary.
EXTRACTION OF DUSTS AND SCOBS PRODUCED DURING POWER TOOL OPERATION
Ɣ Put dust bag to clean heavy dirt or pleated lter (a) into the vacuum cleaner.
Ɣ Place power tool plug in the mains socket (2) (power consumption of connected power tool must not
exceed 2000 W) (g. K)
Ɣ Switch on the vacuum cleaner – press the switch (8) to pos. II.
In this mode of operation vacuum cleaner can only be used with power tool connected. Remember
that the vacuum cleaner will be switched on automatically (with short delay) by power tool connected
to the socket.
Vacuum cleaner socket can be used only for purposes specied in this instruction manual.
When sucking o gypsum dust use pleated lter and dust bag.
WET OPERATION
Do not use the vacuum cleaner to suck o ammable or explosive liquids, such as petrol, oils,
alcohols, solvents etc. and hot or glowing dusts and materials.
Foam membrane lters out large contaminations from liquids.
Ɣ Release xing clamps (3) on both sides of the device and remove upper body (7).
Ɣ Remove pleated lter (a) and/or dust bag.
Ɣ Empty the tank from dirt.
Ɣ Ensure the oat (h) can elevate in its ring in straight line (b) (g. L).
Ɣ Put foam membrane (i) onto the ring (b) of the oat (h) (g. M).
Ɣ Install upper body (7) and secure with xing clamps (3).
When water reaches its maximum allowable level in the tank, sound produced by motor changes
noticeably. Switch o the vacuum cleaner immediately and empty the tank.
EMPTYING DIRTY WATER FROM CONTAINER
Ɣ Place tray or other vessel and unscrew the drain plug (9) (g. N).
Ɣ Once the water has been drained screw in the drain plug (9).
BLOWING THROUGH
Before blowing through (e.g. dirt depositions in corners), remove upper hook for the power cord (12)
located on the upper body (
7) (g. O). Remove suction hose from the connection socket (4) and attach it to
hole in the upper body (7) (g. P).
OPERATION AND MAINTENANCE
Disconnect the tool from power supply network before starting any adjustment, maintenance or
repair.
Ɣ Regular cleaning assures longer maximum suction eciency.
Ɣ Clean dirt and dust o the vacuum cleaner body with damp cloth. Do not allow water to get inside
the motor.
Ɣ Empty, clean and dry carefully the tank each time after cleaning wet dirt and liquids. Liquids and wet
dirt speeds up growth of bacteria.
Ɣ If pleated lter was used, remove and clean with a brush. Frequency of pleated lter cleaning depends on
type and amount of dusts. Replace lter with a new one when necessary. Use only original pleated lters.
Ɣ Float and foam membrane must be cleaned and dried thoroughly to avoid growth of mould.
Ɣ If dust bag was used, replace with a new one when it is full.
Ɣ Store the vacuum cleaner in dry place, beyond reach of children.
Ɣ Entrust replacement of power cord and other repairs only to authorized service workshop.
To Next Page
Loading...
