8
Introduction
Additional Control Panel Features
Additional Control Panel Features
The panel supports gang switching in multi-destination mode. The operator may route
single or multiple sources to multiple destinations in a single operation.
The LCD buttons can be green (for sources), amber (for destinations), yellow, or red. Each
button provides three levels of tally: off, low, and high. Through the menu, high tally can be
set at high or medium brightness and low tally can be set at low or medium brightness,
where high tally is constrained to be brighter than low tally.
The panel’s 24 function buttons and two scroll buttons are backlit. The buttons can be
green or amber. Each button provides three levels of tally: off, low, and high. (You can adjust
the levels of low and high tally, through the menu. LED brightness levels range from 0% to
100%, in 10% increments, with high tally constrained to be brighter than low tally.)
If you assign an X-Y/Multi-Destination button on your panel, it is a toggle: press it once to
place the panel in X-Y mode and press it again to place the panel in multi-destination
mode. (It turns green for X-Y mode and amber for multi-destination mode.)
To Next Page
Loading...