GRAUPNER ULTRA DUO PLUS 60 - Page 3

Charging a NiMH-battery:
Example: six-cell NiMH battery, 4600 mAh
Warning: Be careful! Batteries may explode or burn if the charger develops a fault or if the user
chooses the wrong charging program and / or parameters.
with Bal.-con.
ca. 5 sec. or
ca. 5 sec. or
3 sec.
- = - - - - - - - -
CHARGE
C: 4.6A d 5mV/C 50°C
CHARGE START 5
PROCESS [ NORMAL ]
01]NiMH 7.2V 4600mAh
C: 4.6A d 5mV/C 50°C
ULTRA DUO PLUS 60
GRAUPNER #6478 V1.0
BENUTZERNAME
= - - - - - - - - -
MEMORY [01]
01] NiMH GP 6N-4600
BATTERY SETUP <1/2>
TYPE NiMH
VOLTS _6CL _7.2V
CAPACITY _4600mAh
NEW 01.01.2008
CHARGE SETUP <1/2>
CHG CURRENT _4.6A
PEAK SENS. _5mV/C
PEAK DELAY _3min
TRICKLE _AUTO
CUT-TEMP. _50°C
CHARGE START 5
DELAY TIME
_
___OFF
EXPECT TIME ___0min
EXP.FINSH am00:00:00
00/00/2000 am00:00:00
BATT NAME SETUP<2/2>
01] NiMH GP 6N-4600
^
ABCDEFGHIJKLMNOPQR
STUVWXYZabcdefghijk
lmnopqrstuvwxyz0123
456789 -.,'#_+/
ä ö ü é è
CHARGE SETUP <2/2>
MAX CAPACITY 125%
SAFETY TIMER _75min
FLAT CHECK OFF
REPEAK CYCLE 1T
REPEAK DELAY _30min
CHARGE START
[ NiMH ] BATTERY
-- CONNECT --
__ CHECK __
*CONNECTED CHECK* 5
[6] cells are now
Connected at the
Balancing port
.......Right?
OUTPUT [ _7.320V ]
3 sec.
- Use the ‘Dial’ button and the ‘up’ and ‘down’ buttons to
set all the parameters in the Battery Configuration. In
the Charge Configuration press and turn the ‘Dial’
button to set the parameters. Observe the charging
notes in the battery instructions. If in doubt, select a
charge current of 1 C and start with a Delta-Peak
sensitivity of 5 mV / cell. The maximum capacity should
be set to 120 - 125%.
- Write the battery number on each battery.
- Connect the battery to the selected charge output.
- Press the ‘Dial’ button to initiate the charge process.
First use of the char
g
er
A
-6
5 sec. or
[ NORMAL ] CHARGE
TIME _0:00:00
CAPACITY ____0mAh
VOLTAGE _0.000V
CURRENT +_0.00A
RESISTANCE ___0.0m
BATT TEMP
_
0.0`F