To Next PageTo Next Page
Need help?Do you have a question about the GRAUPNER ULTRAMAT 12 PLUS POCKET CHARGER and is the answer not in the manual?
General| Brand | GRAUPNER |
|---|---|
| Model | ULTRAMAT 12 PLUS POCKET CHARGER |
| Category | Battery Charger |
| Language | English |
Automatic charging detection and current adjustment for Ni-Cd batteries.
Manual charging with a set current for Ni-Cd batteries.
Determines residual capacity or discharges Ni-Cd packs to a set level.
Optimizes Ni-Cd battery capacity and cell balance through cycles.
Discharges and balances up to 6 Ni-Cd cells for optimal performance.
Adjusts automatic termination sensitivity for Ni-Cd batteries.
Automatic charging detection and current adjustment for Ni-MH batteries.
Manual charging with a set current for Ni-MH batteries.
Determines residual capacity or discharges Ni-MH packs to a set level.
Optimizes Ni-MH battery capacity and cell balance through cycles.
Discharges and balances up to 6 Ni-MH cells for optimal performance.
Adjusts automatic termination sensitivity for Ni-MH batteries.
Charges Lithium battery using set capacity/charge current; stops at 110% capacity.
Determines residual capacity or discharges Lithium packs to a set voltage.
Charges or discharges Lithium batteries to their optimal storage voltage.
Displays and allows manual adjustment of Lithium pack cell count.
Sets battery type and capacity, vital for correct charging parameters.
Sets maximum charge current for lead-acid batteries.
Determines residual capacity or discharges lead-acid packs to a set voltage.
Indicates the charger is checking the connected battery before starting.
Signals the end of a charge/discharge process with program name.
Shows "BLC" when the balancer connector is active.
Shows the current input voltage and measured battery resistance.
Displays the voltage of each individual cell in a battery pack.
Indicates the car battery voltage is too low to power the charger.
Alerts to a reversed connection of the battery polarity.
Signals an interrupted connection during charging or discharging.
The safety timer for the process has elapsed.
Detected excessive battery voltage, possibly due to incorrect settings.
Detected insufficient battery voltage, possibly due to incorrect settings.
Excessive cell voltage detected at the balancer input.
Insufficient cell voltage detected at the balancer input.
Balancer connector is not connected or disconnected during operation.
