Need help?Do you have a question about the Gray DMX512 and is the answer not in the manual?
Summary of the steps for correctly assembling DMXPathfinder MR hardware into an equipment rack and connecting external wiring.
Considerations for the installation environment, proximity to power sources, and required conduit/cable runs.
Guidelines for selecting and placing the equipment rack, including height, depth, and clearance requirements.
Details on mounting types of cable termination boards for interface between DMXPathfinder MR modules and external cabling.
Instructions on how input and output cabling enters the rack, bundling, and dressing for connection to terminal blocks.
Steps for unpacking modules, attaching rack mount ears, powering up, and removing rubber feet before installation.
Procedure for stripping cable, applying heat shrink, and connecting signal wires to terminal blocks.
Instructions on how to assign outputs to inputs by setting rotary selector switches on the Crosspoint Card.
Procedure for powering up the DMXPathfinder MR modules and verifying the illumination of power LEDs to detect wiring issues.
Guidance on replacing defective circuit cards within modules, recommending powering down before removal or insertion.
Overview of system testing using diagnostic instruments like Fluke 650 Cable Meter and Goddard Design Li'l DMX'ter.
To Next Page
General