Refer to Fig. 97 for the following steps.
Refer to Fig. 98 for the following steps.
17
.
Place the cabinet bottom on your work surface
22,
as shown in Fig. 97.
18
.
Make sure that all four brackets are lined up
perpendicular with ‘the cabinet top before
proceeding.
23
.
19
.
Hold the cabinet top so that it can be folded onto
the cabinet bottom like a hinge. Carefully
position all wires so that they will not be pinched
between any metal or other parts when the
24
-
*
cabinet top is assembled to the cabinet bottom.
20
a
Gently lower the cabinet top onto the cabinet
bottom. Observe the wires to be sure they are
not pinched between any parts.
2~
.
21. Once the cabinet top is positioned firmly onto the
-
26
l
cabinet bottom, hold the two cabinet halves
tightly together while you turn the unit over.
27
-
l
Continue to hold the cabinet tightly together.
28
.
While holding the cabinet together, install four
(4) 3 x 8mm screws with 3mm
lo&washers
into
the four (4) holes in the bottom of the cabinet-
IGHTEN
THESC-
.
Install three (3) 3 x 8mm screws with 3mm
lockwashers into the three holes on the left side
of the cabinet.
DO
NOmAE
zGlWYS*
Install
three (3) 3 x 8mm screws with 3mm
lockwashers into the three (3) holes on the left
side of the cabinet.
DO
NOT
Tm
THE
SXEIE
Tighten the screws installed in Step 22.
Tighten the screws installed in Step 23.
Tighten the screws installed in Step 24.
This completes construction of your
Graymark
Model 808 Triple Power Supply/Bread board.
55
To Next Page
Loading...