2 -3
#4
assembly instructions
Installation.
It is essential to follow these three steps
to achieve a correct assembly:
1. Section pieces must only be placed on
the curve area located at the lower part
of the pool (semi-circumferences), sec-
tion pieces must not to be placed on the
straight parts. The lower section pieces
are curve (PI) and they have a flap (page
16). Flexible section parts (PCF) are to be
placed on the upper part of the pool in
both curve and straight parts (page 21).
2. When closing the pool plate (CH) us-
ing the screws (TC), make sure the screw
heads are facing inwards and the wash-
er and the blind nut outwards (page 19).
Tighten the screws without distorting
the plate.
Important: The liner used in the
manufacturing of all our pools, is
developed for exposition to heat
and ultraviolet rays for long pe-
riods. Therefore, under certain
weather and usage conditions,
the liner qualities can vary slight-
ly. The interior liner of the pool is
manufactured from flexible PVC
(thermoplastic). The properties of
this material allow optimal insta-
llations conditions when the out-
side temperature is between 20
°C and 25 °C.
Note: Temperature too low: hard
and rigid liner; later, too small.
Temperature too high: flexible
and elastic liner; later, too big.
14
To Next Page
