OK
#2
3,5 m
EN
preparation of the site
Preparation
of the site.
Installation site
Our pools are designed to be installed
directly on the ground and for outdoor
family use. The ground must be firm,
smooth, and perfectly flat.
Do not forget: 1000 l. = 1 m
3
= 1000 Kgs.
Do not use rubber or similar materials,
or those in which the sheet metal can
become stagnant.
Recommendations for choosing the
best location for your pool
→ Choose a place where you will have
to dig as little as possible to level the
ground.
→ An area where in the event of rain, floo-
ding will not occur.
→ Where there are no underground con-
nections (water, gas, electricity, ...).
→ Do not install under power lines.
→ Protected from the wind and free from
trees since the pollen and leaves can
make the pool water dirty.
→ A sunny area, where there is most sun in
the morning.
→ Near an electricity outlet, water outlet,
and drainage.
NEVER DO THE INSTALLATION ON: sloping, uneven, loose, soft or sandy ground with stones.
minimum
5
To Next Page
Loading...
