GRE CSPA - Product Assembly; Handle and Pole Assembly

5

CAUTION: Put the charging cover after charging. Placing cleaner in
water without putting the charging cover will void your warranty.
NOTE: Charge the cleaner 3 hours prior to the first use.
Normally cleaner can be operated for 45 to 60 minutes after fully charged.
Set Up for Operation
Handle assembly
Insert the handle as shown behind big department, according to needs, looking
for what kind of convenient way to clean the wall and bottom of the POOL/SPA,
you find easier to hold the cleaner when cleaning the pool / spa wall and
bottom. Insert the handle into the cleaner as shown until the side pin on the
handle is secured in the Handle Locking Hole on the cleaner.
To release the handle, press down the side pin and pull out the handle.
Telescopic pole (not included) assembly
Insert the end(with one side pin)of the Pole Connector into the cleaner as
shown until its single side pin is secured in the Hand Locking Hole of the
The arrow of transparent suction head part
and transparent body should be aligned, and
then you can put down the transparent
garbage can to the bottom of transparent
body. Then rotate 90 degrees rightly ( from
open to close).
www.PiscinasDesmontables.com