6
cleaner. Slide and align the side holes of the telescopic with the side pins of the
Pole Connector.
To release the telescopic pole, press down two side simultaneously and pull
out the pole.
Suction head assembly
Insert the Suction Head directly to the suction hole of the cleaner tightly by
hand.
Brushes on the Suction Head can be removed by pulling out directly from the
head.
For Vinyl, liner and fibreglass pools, it is recommended to keep the brushes on
the suction head to prevent damage to your pool.
Cleaning the cleaner after using the electric cleaner:
In order to have the better suction effect,
please operate the electric cleaner as the
following instructions:
(1) Insert the suction head when suction the
small pebbles and leaves, as the Picture
A shows.
(2) No need to insert the suction head onto
the electric cleaner when suction the
stones and other large garbage and so on,
as the Picture B shows.
(1) Take the transparent body off the electric
cleaner (following the OPEN-CLOSE
direction, rotate to OPEN direction 90
degrees), and take the garbage out of the
transparent body, and then clean it.)
(2) Take out the rear part of filter bag, and
take out the filter bag, and get out the
garbage, and then clean the filter bag.
www.PiscinasDesmontables.com
To Next Page
Loading...