EN
ASSEMBLY SUGGESTIONS: ISOTHERMAL COVERS
Suggestions for correct positioning: / Installation suggestion
Place the surface with air bubbles of the cover in contact with the surface of the water,
leaving the at surface of the cover visible
Flat surface
facing up.
Bubble surface
facing down
Maintenance suggestions
To assure a long life of the cover, it is necessary / obligatory to remove it from the pool.
- When the temperature of the water reaches 30 degrees Celsius.
- At that time and during the next 48 hours, perform the shock chlorination.
(The chlorine content should not exceed 1 PPM)
After having removed the cover from the pool, (we strongly recommend using a swimming pool
roller):
- It must be protected against solar radiation.
- If you do not have a rolling device, it is recommended to fold it in several places or roll it on
itself to keep it protected from sunlight.
You should never leave the cover inside the pool during winter.
- It should be rinsed with clean water, dried and stored in a place protected from ice and sunrays.
Stability of the dimensions:
- A 1 to 2% variation of the cover is possible. We are not responsible for variations equal to or
lower than 5cm.
Avoid contact with sharp or abrasive edges, because these can cause wear by friction, tears or
cracks as well as removal of the colour, which are not covered by guarantee
You should carefully follow the pre-
vious suggestions to have the benet
of the guarantee.
Contents of packet:
- The bubble cover guarantees the season
When using the tarpaulin, shield it from
sunlight
To Next Page
Need help?
General
