EasyManua.ls Logo

GREAT PLANES Ultimate 40 - User Manual

GREAT PLANES Ultimate 40
48 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
WARRANTY
Great Planes Model Manufacturing Co. guarantees this kit to be free from defects in both material and
workmanship at the date of purchase. This warranty does not cover any component parts damaged by use or
modification. In no case shall Great Planes' liability exceed the original cost of the purchased kit. Further, Great
Planes reserves the right to change or modify this warranty without notice.
In that Great Planes has no control over the final assembly or material used for final assembly, no liability shall be
assumed nor accepted for any damage resulting from the use by the user of the final user-assembled product. By the
act of using the user-assembled product, the user accepts all resulting liability.
If the buyer is not prepared to accept the liability associated with the use of this product, the buyer is advised
to return this kit immediately in new and unused condition to the place of purchase.
While this kit has been flight tested to exceed normal use, if the plane will be used for extremely high stress flying, such
as racing, the modeler is responsible for taking steps to reinforce the high stress points.
READ THROUGH THIS MANUAL BEFORE
STARTING CONSTRUCTION. IT CONTAINS
IMPORTANT WARNINGS AND INSTRUCTIONS
CONCERNING THE ASSEMBLY AND USE OF
THIS MODEL.
P.O. Box 788 Urbana, IL 61803 (217) 398-8970
©Copyright 1998 ULT4P03 V1 1
Question and Answer IconNeed help?

Do you have a question about the GREAT PLANES Ultimate 40 and is the answer not in the manual?

Summary

SAFETY PRECAUTIONS

DECISIONS YOU MUST MAKE

Engine Selection

Discusses suitable engine choices and their impact on firewall construction.

PRECAUTIONS

BUILDING SUPPLIES AND TOOLS

DIE-CUT PATTERNS

BUILD THE TAIL SURFACES

BUILD THE FIN

BUILD THE RUDDER

HINGE THE TAIL SURFACES

FIT THE TORQUE RODS

BUILD THE BOTTOM WING

SHEET THE TOP OF THE WING

SHEET THE BOTTOM OF THE WING

COMPLETE THE BOTTOM WING

BUILD THE AILERONS

BUILD THE FUSELAGE

ASSEMBLE THE FUSELAGE SIDES

INSTALL THE FORMERS

MOUNT THE WING ON THE FUSELAGE

INSTALL THE STABILIZER & FIN

BUILD THE TOP WING

Build the Wing

Step-by-step construction of the top wing structure.

INSTALL THE AFT ROOT RIBS

FINISH SHEETING THE TOP OF THE WING

SHEET THE BOTTOM OF THE WING

ENGINE INSTALLATION

ASSEMBLE THE COWL

COVERING

COVERING TECHNIQUE

BALANCE THE MODEL LATERALLY

FINAL HOOKUPS & CHECKS

INSTALL THE HARDWARE

RADIO INSTALLATION

Install the Rudder, Elevator & Throttle Servos

Instructions for installing the servos for rudder, elevator, and throttle control.

INSTALL THE AILERON SERVO

SET THE CONTROL THROWS

CHECK THE WING INCIDENCE

BALANCE YOUR MODEL

PREFLIGHT

CHARGE THE BATTERIES

BALANCE THE PROPELLER

FIND A SAFE PLACE TO FLY

GROUND CHECK THE MODEL

RADIO CONTROL

TAKEOFF

FLIGHT

LANDING

GREAT PLANES Ultimate 40 Specifications

General IconGeneral
BrandGREAT PLANES
ModelUltimate 40
CategoryToy
LanguageEnglish

Related product manuals