V240 and V200 (Wingle) Programming
V240 pre Facelift (Wingle 3)
1. Open the Drivers front door and insert the key into the ignition.
2. Turn the key from Off to ON 5 times finishing in the ON position.
3. The flashers will flash once to indicate programming mode has been entered.
4. Push either the lock or the unlock button on the remote.
5. If successful, the flashers will flash Twice.
6. If you have more than 1 remote to program push any button on the second remote immediately
after programming the first.
V200 and V240 Facelift (Wingle 5)
1. Open the Drivers front door and insert the key into the ignition.
2. Turn the key from Off to ON 5 times within 5 seconds finishing in the ON position.
3. The flashers will flash once.
4. Wait (approx. 5-8 seconds) until the flashers flash once again and then turn the key Off and On 3
more times finishing in the ON position.
5. The flashers will flash once more indicating that the programming mode has been entered.
6. Push either the lock or the unlock button on the remote.
7. If successful, the flashers will flash Twice.
8. If you have more than 1 remote to program push any button on the second remote immediately after
programming the first.
9
To Next Page
Loading...