Great Wall V240 - User Manual

Keyless Entry and Immobilizer
Programming Methods
Part Numbers and Component
Identification
X240
X200
V240
V200
SA220
1

Summary

Keyless Entry and Immobilizer System

X240 (Hover) Programming (PreFace Lift)

Programming for Module VA-873 D1

Procedure for programming remote key for Module VA-873D1 on X240 (Hover).

Programming for Module VA-873 DUP

X240 and X200 (H5) Programming (Face Lift)

Key Teach Procedure

V240 and V200 (Wingle) Programming

V240 Pre Facelift (Wingle 3) Programming

V200 and V240 Facelift (Wingle 5) Programming

SA220 (Sailor) Programming Method “A”

Procedure A Steps

SA220 (Sailor) Programming Method “B”

Procedure B Steps

ECU and Immobilizer Unit Management

ECU Swap and Replacement

Immobilizer Unit Swap and Replacement

Swapping an ECU (Petrol Vehicles)

ECU Swapping Procedure

Detailed steps for swapping an ECU between donor and problem vehicles for petrol models.

Replacing an ECU with a New Unit (Petrol)

New ECU Replacement Procedure

Steps for replacing an ECU with a new unit for petrol vehicles.

Swapping an Immobilizer Unit

Immobilizer Swapping Procedure

Steps for swapping an immobilizer unit between vehicles, covering petrol and diesel.

Replacing an Immobilizer Unit

New Immobilizer Replacement Procedure

Steps for replacing an immobilizer unit with a new one, for petrol and diesel.

Programming Immobilizer Keys (All Models)

Immobilizer Key Learning Steps

General procedure for programming immobilizer keys across all Great Wall models.

Great Wall V240 Specifications

General

Brand	Great Wall
Model	V240
Category	Automobile Electronics
Language	English