Need help?Do you have a question about the GREE ELECTRIC ETAC2-07HC230VA-A and is the answer not in the manual?
Configuration possibilities via dip switches and keypad for exact application setup.
Unit requires an accessory power cord or hard wire kit for installation.
Discusses recommended wire size and single branch circuit requirement.
Units ship without a sleeve; standard or retrofit sleeves can be used.
Inspect wall sleeve thoroughly before installation; manufacturer not responsible for defects.
Installations using pre-manufactured windows may require an accessory baffle kit.
Steps include removing shipping tape, front panel, and junction box.
Explains how to configure unit settings using adjustable control dip switches.
Details the function of each dip switch for various unit settings.
Provides a visual guide and function table for dip switches.
Describes how to enter and modify configuration settings using the unit keypad.
Unit's computer continuously checks key components for proper operation.
Defines the meaning of different STATUS LED flashes and display codes.
Shows the wiring diagram for connecting the thermostat to the ETAC II unit.
Covers configuring dip switches, installing labels, and mounting the thermostat.
Importance of cleaning filters and how to perform the task.
Lists possible causes and solutions when the unit fails to start.
Addresses problems with the unit not cooling or heating the room effectively.
General| Brand | GREE ELECTRIC |
|---|---|
| Model | ETAC2-07HC230VA-A |
| Category | Air Conditioner |
| Language | English |
To Next Page