DC Inverter U-match Series Cassette Type Unit
36
Gas leakage of
ceiling
Condensate Water drops
Gas leakage
(2) After the screws are tightened, if there is still a gap between the ceiling and the
decorative front panel, adjust the height of the unit again (as shown below).
No seam
If the lifting level of indoor unit and the drain pipeline
won't be affected, it's fine to adjust the height of
indoor unit through the holes on the corners of the
front panel.
(3) After installing the front panel, make sure there’s no gap between the unit and
the front panel.
(4) Circuit of the decorative front panel.
Connect the front panel to the main body through the corresponding slots.
Match the slots according to their different size.
Match the corresponding slots
To Next Page
Loading...
