Gree GAA07AA-D3RNA2C

To Next Page

To Previous Page

Service Manual

Technical Information

(continued)

TO OPERATE ON FAN ONLY:

PRESS

MODE BUTTON

CHOOSE

FAN ONLY

Note: Use this function only when cooling is not desired, such as for room air circulation. You can choose any fan speed you prefer,

EXCEPT AUTO FAN.During this function, thedisplay will show theactual current temperature, not theset temperatureas in the cooling mode.

TIMER-DELA

FIRST DO THIS:

PRESS TIMER BUTTON

PRESS TEMP/TIMER

BUTTON

THE TIME CHOSEN:

START/ST A

Note 1: ForDelay Stop,the unit must be in theON position.

Note 2: ForDelay Start, the unitmustbeinthe OFF position.

To adjust timer setting, tap or hold the UP arrow (^) or DOWN arrow (v) to change the delay time by 0.5 hour increments up to 10 hours,

then by 1 hour increments up to 24 hours. The control will count down the timer remaining until start (8, 7.5, 7, etc.). After

set Timer,the unit will enterinto Timermode by 5seconds, then Timerlight on, Set light off. In Timermode: Set temperature

and fan speed keeps previously set temperature and fan speed; Temperature display set temperature, no display if power

turn off; Press Timer once, LED display remaining time of set time, LED return to set temperature by 5 seconds;

When in Fan Only mode, LED only display room temperature, do not display set temperature.Turning the unit "ON" or

"OFF" at any timer will cancel the Delay Start/Stop function. Thedelay Start/Stop featurewillworkuntil theunit either starts

or stops. Once this has happened then the above steps have to be repeated again.

COOL

FEA models)

PRESS

MODE BUTTON

SELECT COOL

Note

：This feature can be used with any combination of FAN Speeds, Timer, or Sleep Modes. When in the “Cool” Mode, the fan will

un continuously while cool is needed. The temperature will automatically be maintained anywhere between 61°F (16°C) and 86°F

(30°C).

When the room set temperature is satisfied, the fan will cycle off and on to circulate and sample the room air. If the air conditioner

is off and is then tur

ned on while set to a Cool setting or if turned from a fan setting to a Cool setting, it may take approximately 3 minutes

or the compressor to start and cooling to begin.

SEE

Other manuals for Gree GAA07AA-D3RNA2C