4
This symbol indicates an imminently hazardous situation that, if not avoided, will
cause severe personal injury, death, or substantial property damage.
DANGER
This symbol indicates a potentially hazardous situation that, if not avoided, can
cause severe personal injury, death, or substantial property damage.
WARNING
This symbol is accompanied by tips and/or relevant information that are essen-
tial to the proper operation of the equipment.
NOTE
SAFETY GUIDELINES
SAFETY SYMBOLS DESCRIPTION
The following symbols are used throughout this manual to indicate immediate or potential hazards. It
is the owner’s responsibility to read and follow all safety information and instructions accompanying
these symbols. Failure to heed safety information increases the risk of serious injury or death, property
damage and/or product damage.
CONFORMITY AND RANGE
▪ Please read this manual carefully before using the appliance and keep it for future reference.
▪ Use the appliance only in accordance with the instructions in this booklet. These instructions are
not intended to cover all possible conditions and situations. As with any household appliance,
common sense and caution are therefore always recommended for installation, operation and
maintenance.
This symbol indicates a potentially hazardous situation that, if not avoided, will
or can cause minor personal injury or property damage.
CAUTION
EXCEPTION CLAUSES
The manufacturer will not assume any liability when personal injury or property damage is caused by
the following reasons :
1. Damage the product due to improper use or misuse of the product.
2. Modifying, altering, maintaining or using the product with other equipment without complying with
the manufacturer’s instruction manual.
3. After verication, the product defect is directly caused by corrosive gas.
4. After verication, the defects are caused by mishandling during product transportation.
5. Operation, repair, maintenance of the unit without complying with the instruction manual or related
regulations.
6. After verication, the problem or dispute is caused by the quality specications or performance of
parts and components produced by other manufacturers.
7. The damage is caused by natural disasters, bad operating environment or force majeure.
CAUTION :
To Next Page