83
Installation and Maintenance
Service Manual
motor and disconnect the leading wire
insert of the motor. Then remove the
motor.
motor support and lift the motor support to
remove it.
subassembly; loosen the wire bundle and
unplug the wiring terminals. Then lift the
electric box to remove it.
sheet and then remove the isolation
sheet.
Procedure
8.
9.
Remove motor and motor support
Unsolder the welding joint connecting the
capillary, valves and the outlet pipe of
condenser to remove the capillary. Do not
block the capillary with welding slag
during unsoldering.
10.
Remove Electric Box Assy
Remove isolation sheet
11.
a
Remove compressor
Step
motor support
motor
electric Box Assy
isolation sheet
liquid valve
gas valve
To Next Page
Loading...
