5
1. SAFETY PRECAUTIONS
Electrical Safety
CAUTION : The power cord of this air conditioner contains a current sensing device designed to
reduce the risk of re. Please refer to the Operation of Current Device section below for more details.
If the power cord is damaged, it cannot be repaired. It must be replaced with a power cord from the
product manufacturer.
▪ The power cord is equipped with a 3-prong grounding plug that can only be used with a standard
3-prong wall outlet to minimize the risk of electric shock. If you have a 2-prong plug, it is your responsi-
bility to replace it with a properly grounded 3-prong wall outlet.
▪ Do not use a power cord that has any damage or cracks along the length or at the connector. A dam-
aged power cord must be replaced with a new cord obtained from the manufacturer. Please contact
Customer Service for replacement options.
▪ Do not alter the length of the power cord or share an outlet with another device. Doing so may result in
electric shock or re.
▪ Always use a dedicated power circuit. The voltage of the plug must match the voltage rating on the
nameplate.
▪ Do not use an outlet if it is loose or damaged. Doing so may cause electric shock.
▪ Never use an extension cord, surge protector, or power strip adapter with this unit.
Operation of Current Device
The power supply cord contains a current device that senses
damage to the power cord. To test your power supply cord, do
the following :
1. Plug the power supply cord.
2. The power supply cord has 2 buttons on the plug head. Press
the TEST button. You should hear a clicking sound as the
RESET button pops out.
3. Press the RESET button. Again, you should hear a click as the
button engages.
4. The power supply cord is now supplying electricity to the unit
(on some devices this is indicated by a light on the plug head).
Notes :
▪ Do not use the power cord to turn the unit on or off.
▪ Always make sure the RESET button is pressed down for proper operation.
▪ The power cord must be replaced if it fails to reset when the TEST button is pressed, or if it cannot be
reset. Please contact Customer Service.
▪ If the power cord is damaged, it cannot be repaired. It MUST be replaced with a new power cord. Please
contact customer service.
NOTICE : If you turn off the air conditioner, wait at least three minutes before turning it on again. This
prevents the unit from blowing a fuse or tripping a circuit breaker.
FIGURE 1
RESET button
TEST button
Power supply plug
(appearance may differ)
To Next Page
Loading...
