55
Maintenance
Service Manual
Produce
10
Steps
12
screw
nut
support board
Remove support board and compressor
Twist off screws fixing support board and
remove 2 support board. Unsolder the
spotweld between compressor and
condenser, remove 3 nuts fixing
compressor and then remove the
compressor.
compressor
11
Remove air duct sub-assy
Remove screws fixing air duct sub-assy,
and then remove the air duct sub-assy.
screw
air duct sub-assy
Remove reversion loop
Remove screws fixing reversion loop,
and then remove the reversion loop.
screw
reversion loop
To Next Page
Loading...
