22
Remove Collected Water: Continuous
Drainage Lower Hole Option
• Turn off and unplug the unit before draining.
• Move the unit to a suitable place, keep the unit vertical.
• Take the
Drainage Hose from the Pipe Clip, and pull out the Rubber Plug in the Drainage Hose
to discharge the water.
• After discharging the water, replace the
Rubber Plug in the Drainage Hose and then place the
Drainage Hose onto the Pipe Clip.
• After the water is removed, and the compressor has been stopped for 3 minutes,
the unit will resume operation.
CLEANING AND MAINTENANCE
NOTE: During cooling or drying operations, water will condense and drain into the chassis.
When the chassis is full with water, a buzzer will sound and “H8” will display on the unit.
The unit will shut off.
To Next Page
Loading...
Need help?
General
