Gree GTH36K3FI - Page 147

U-Match Series DC Inverter Service Manual
144
Disassembly of fan and motor components
Remark: Make sure that the power supply is cut off before disassembling and protect all the
parts during disassembly, especially the fastening screws for fans.
Step
Illustration
Handling Instruction
1. Disassembly of
front and back
scroll cases
●Press the buckle at the
joints of front and back
scroll cases with hands
and pull upward to
remove the front scroll
case. Then remove the
screws on the back
scroll case. Lift the
buckle of back scroll
case with hands and
remove it. (As is shown
in the graph, circle
represents 2 screws on
left and right.)
Disassembly of fan and motor components
Remark: Make sure that the power supply is cut off before disassembling and protect all the
parts during disassembly, especially the fastening screws for fans.
Step
Illustration
Handling Instruction
2. Disassembly of
fans
●Unscrew the 2 screws
of coupling, take out
the rotating shaft and
louver, then loosen the
tighten screw of louver
to remove the louver.
3. Disassembly of
bearing fixing
plates
●Unscrew the 3 screws
and 2 nuts of support to
remove the mounting
support
4. Disassembly of
motor
●Loosen the 2 screws of
the motor attaching
clamp, remove the
motor attaching clamp
and motor attaching
clamp subassembly to
remove the motor.