Gree GUD100PHS/A-T

GREE U-Match 5 SERIES UNIT SERVICE MANUAL
116
Removal of fan and motor
Note: Before removing the motor, power must be cut off.
Step
Picture
Work instruction
9. Install the water tray.
●Direct the 4 corners of water
tray to the 4 corners of the unit
and then press them. Use a
screwdriver to tighten the
screws in the 4 corners.
●Connect the power cord and
water pump wire.
●Place back the cover of
electric box and the clamp of
power cord. Then tighten the
screws with a screwdriver.
Removal and installation of drain pump
Step
Picture
Work instruction
1. After removing the front
panel as instructed above,
loosen the screws of the
water tray.
●Use a screwdriver to loosen
the screws of water tray.
2. Remove the cover of
electric box and the clamp
of power cord.
●Twist off the screws and open
the cover of electric box and the
clamp of power cord.
3. Remove the motor wire
and water pump wire.
●Remove the motor wire and
water pump wire in the electric
box.