GREE                                                                                                    U-Match 5 SERIES UNIT SERVICE MANUAL
 
121 
 
Note: Make sure power is cut off. Take good care of the copper pipe and aluminum fins. If the removal takes a long 
time, please put the copper pipe under pressure.   
3. Remove the 
evaporator.   
●Take off the evaporator. 
The removed evaporator 
is as shown in the 
picture. 
 
4.5.2.3 Floor Ceiling Unit 
Take model GUD160ZD/A-T as an example.   
Note:  Before  removal,  make  sure  power  is  cut  off.  During  the  removal  procedure,  take  good  care  of  all  the 
components. Do not place the filter near any heat source. 
Remove the 
sub-assembly of front 
grill.
 
●Twist  off  the  2  hooks 
of  the  grill  and  the 
screws of the hooks.   
●Open the grill and 
remove 2 lower 
clamps. Then remove 
th
e grill.   
Remove the right and left decorative boards 
Note:  Before  removal,  make  sure  power  is  cut  off.  During  the  removal  procedure,  take  good  care  of  all  the 
components. Do not scratch the appearance components.   
Remove the left and 
right panels. 
 
●Use a screwdriver to 
loosen the screws, as 
shown in the picture. 
Then pull the right 
and left panels 
upward. (Lines in the 
picture indicate the 
positions of screws.)