GREE U-Match 5 SERIES UNIT SERVICE MANUAL
106
Disassembly of compressor
Note: Before removing the compressor, make sure there is no refrigerant in the pipeline and power is cut off.
5.Fix the new compressor back
onto the chassis.
●After replacing the compressor,
tighten up the screws at the foot
of compressor.
6.Connect the compressor suction
port and exhause port with the
pipes.
●Weld the compressor
connection pipes and connect
them to the compressor.
Note: When replacing the
compressor, avoid touching the
nearby pipeline and components.
8.Connect the compressor wires.
●Connect the compressor wires
to the wire terminals on the top of
compressor.
Note: When connecting the
wires, be sure to match the colors
with the corresponding wire
terminals.
To Next Page
Loading...
