Gree GUD125ZD/A-T

GREE U-Match 5 SERIES UNIT SERVICE MANUAL
123
Removal of evaporator
Note: Make sure power is cut off. Take good care of the copper pipe and aluminum fins. If the removal takes a long
time, seal the copper pipe.
Step
Picture
Work instruction
Remove the evaporator
assembly.
●
Twist off the 6 screws
of the evaporator, 3
screws of the plate
board of water
releasing flume, and 2
screws of the water
tray. Then remove the
evaporator.
Removal of display panel and fan assembly
Note: Before removal, make sure power is cut off. During the removal procedure, take good care of all the
components.
Step
Picture
Work instruction
Remove the display
panel and fan assembly.
●First remove the
display panel, next the
bracket and then the
swing motor mounting
plate.
Removal of fan and motor
Note: Before removal, make sure power is cut off. During the removal procedure, take good care of all the
components, especially the screws of fan.
Step
Picture
Work instruction
1.Remove the
volutes.
●Press the retaining ring at
the joint of front and rear
volutes. Then pull up the
front volute. Then loosen the
screws of the rear volute. Lift
up the retaining ring of the
rear volute and take it off. (As
shown in the picture, the
lines indicate the screws on
both sides of the volutes.
2. Remove the
fan.
●Loosen the 2 screws of the
coupler. Take out the shaft
and axial flow fan. Loosen
the screws of axial flow fan
and remove the axial flow
fan.