Gree GUD50W/NhA-T - Page 116

GREE U-Match 5 SERIES UNIT SERVICE MANUAL
113
Model: GUD35W/NhA-T, GUD50W/NhA-T, GUD71W/NhA-T, GUD85W/NhA-T
Removal of condenser
Note: Before removing the condenser, make sure there is no refrigerant in the pipeline and power is cut off.
Step Picture Work instruction
1. Remove the panels.
 Remove the upper, lower and
front panels.
2. Remove the electric box.
 Loosen the wire clamp at the
bottom of the electric box.
 Unscrew the screws of electric
box.
 The connection wires inside
and outside the electric box
should be removed.
3. Remove motor support.
 When removing the motor
support, be careful to protect
the components.
4. Remove the condenser.
 Heat up the welding points of
connection pipes through gas
welding until the pipes break
off. Note: When welding the
pipes, do not let the flame
burn the other components.
The welding points of
condenser are steel and
copper welding points. Be
sure to maintain the welding
quality.