To Next PageTo Next Page
Need help?Do you have a question about the Gree GUD50T/A-T and is the answer not in the manual?
General| Energy Efficiency Ratio (EER) | 3.21 |
|---|---|
| Refrigerant | R410A |
| Compressor Type | Rotary |
| Type | Split System |
| Indoor Unit Noise Level | 42 dB(A) |
| Operating Temperature (Heating) | -7-24°C |
| Installation Type | Wall Mounted |
| Cooling Capacity | 5000 W |
| Power Supply | 220-240V, 50Hz |
| Weight (Indoor Unit) | 9 kg |
| Weight (Outdoor Unit) | 32 kg |
| Outdoor Unit Weight | 32 kg |
| Operating Temperature (Cooling) | 18-43 °C |
Defines hazard symbols like PROHIBITED, WARNING, NOTICE, and OBSERVED used throughout the manual.
Outlines prohibited actions, warnings, and notices for safe operation and installation of the unit.
Covers initial preparation, refrigerant notices, and general installation guidelines before proceeding.
Guides on installing the indoor unit, including hoisting, leveling, and suspension bolt installation.
Provides instructions for installing the outdoor unit on the ground, including drainage considerations.
Guides on performing vacuum pumping and leak detection for the refrigerant circuit.
Specifies how to add refrigerant, including quantities and necessary checks.
Outlines preparation steps and operation procedures for the initial test run of the air conditioner.
Provides a table of common problems, their causes, and corrective measures for non-running or poor-effect units.
Lists error codes displayed on the unit or controller and their corresponding meanings for diagnostics.
Covers crucial safety checks and procedures for personnel servicing systems with flammable refrigerants.
Details checks for refrigeration equipment and electrical devices during servicing to ensure safety.
Outlines procedures for refrigerant removal, evacuation, charging, decommissioning, and recovery with safety measures.
