Gree GUD71P/A-T - Page 125

GREE U-Match 5 SERIES UNIT SERVICE MANUAL
120
Removal of water tray
Note: Before removal, make sure power is cut off. During the removal procedure, take good care of all the
components.
Step
Picture
Work instruction
1.Remove the cover
plate.
●Loosen the screws of cover
plate and then remove the
cover plate. (As shown in the
picture, the circle indicates 6
screws of the cover plate.)
2. Remove the water
tray.
●Loosen the screws of water
trap. Pull it up and remove it.
The removed water tray is as
shown in the picture.
Removal of evaporator
Note: Make sure power is cut off. Take good care of the copper pipe and aluminum fins. If the removal takes a long
time, please put the copper pipe under pressure.
Step
Picture
Work instruction
1. Remove the screws
on the side plate of
evaporator.
●Remove the screws of
evaporator and the screws
that connect the upper
cover plate to the left and
right side plates.
2. Remove the sealing
plate the connects to
the evaporator valve
and the screws that
connect to the flange.
●Remove the screws of
the sealing plate of valve.
Then remove the sealing
plate of valve. Remove the
screws that connect the
evaporator to the flange.