Gree GUD71P/A-T - Page 90

GREE U-Match 5 SERIES UNIT SERVICE MANUAL
85
Removal of fan and motor
Note: Before removing the fan, make sure power is cut off.
Step
Picture
Work instruction
2. Remove the fan.
●Use a wrench to remove the
specialized nut and gasket of the
fan.
Note: Please keep the nut and
gasket safe after removing them
from the fan.
3. Remove motor.
●Use a screwdriver to unscrew
the bolt of motor.
Note: Motor wire should be first
removed from the electric box.
4. Install the motor.
●Replace with a new motor. Then
tighten up the screw bolt.
5. Install the fan.
●Install the fan in place. Put on
the gasket and use a wrench to
secure the screw nut.
Note: After installing the fan, turn
the fan by hand to see if it can run
normally. If not, please check for
the reason.
6. Install the grill.
●After replacing the motor, use a
screwdriver to tighten up the
screw bolt that secures the motor.