To Next PageTo Next PageWhy is my Gree Air Conditioner not heating well?
If your Gree Air Conditioner isn't heating effectively, begin by cleaning or replacing the air filter. Make sure that all doors and windows are firmly closed. Increase the set room temperature. Check for refrigerant leaks. If the outdoor temperature is below -5°C, consider using an alternative heating source. Finally, check the control loop for any abnormalities.
What to do if my Gree GUHD36NK3FO won't start?
If your Gree Air Conditioner won't start, first check the power supply connection. If that's not the issue, inspect for electrical leakage and reset the leakage switch. Also, ensure the operating keys are unlocked. Finally, check the control loop for any failures.
Why is my Gree Air Conditioner not cooling properly?
If your Gree Air Conditioner isn't cooling well, start by cleaning or replacing the air filter. Also, reduce any heat sources or the number of people in the room. Ensure all doors and windows are closed, and remove any obstructions from the air intake or outlet. Check that the set temperature isn't too high and inspect for refrigerant leakage. If the issue persists, the room temperature sensor may need checking or replacing.
What to do if my Gree GUHD36NK3FO Air Conditioner has a malfunction of the outdoor ambient temperature sensor?
General| Refrigerant | R410A |
|---|---|
| Indoor Unit Dimensions (mm) | 800 x 300 x 500 |
| Outdoor Unit Dimensions (mm) | 800 x 320 x 570 |
| Weight (Indoor Unit) | 10 kg |
| Weight (Outdoor Unit) | 30 kg |
| Indoor Unit Weight | 10 kg |
| Outdoor Unit Weight | 30 kg |
Key safety warnings and precautions for installation and operation.
Details the necessary electrical specifications, including wire size and fuse capacity.
Step-by-step instructions for installing the indoor unit, including drilling and mounting.
Procedure for evacuating the system and checking for gas leaks.
Guidelines and procedures for safe and correct electrical wiring of the unit.
Common failure modes, possible reasons, and initial checks for troubleshooting unit issues.
