81
Installation and Maintenance
Service Manual
Step Procedure
1.Remove lter
a Open the panel.
b
Loosen the clasp shown in the g and then pull the left
lter and right ler outwards to remove them.
2.Remove horizontal louver
Push out the axile bush on horizontal louver. Bend
the horizontal louver with hand and then separate the
horizontal louver from the crankshaft of step motor to
remove it.
Location of step motor
Axile bush
Panel
Clasps
Left lter and right ler
Horizontal louver
18/24/28K
To Next Page
Loading...
